Air Gun and Paintball Fill Lines

For filling PCP (Pre Charged Pneumatic) Air rifles, air pistols and paintball guns

Standard and Extended High Quality Fill Lines (Whips)

We have found that many people struggle with fill line hoses that are just too short. With the increase in shooters using a dive cylinder for filling pre-charged equipment, we have met the demand for extended fill lines by offering the selection of fill lines detailed below. Not only are the reduced risks of damage to your equipment from struggling to hold everything in position plainly obvious, but the Health and Safety benefits of using a longer line to reduce bottle handling and the reduction of vigorous gymnastics are also worth a mention!

With our extended range of high quality fill lines, you can quickly and easily fill your equipment and leave your divers bottle standing in the corner, or if you are out on shooting trip, there is now no need to remove your charging cylinder from the boot of the car.

High Quality Fill Lines, A Brief Guide.

We offer two types of high quality fill lines.

1. The Ultima Fill Line.



The Ultima Fill Line offers all of the benefits and none of the drawbacks of other types of fill line available. Pressure rated to 400BAR, the Ultima Fill Line has a 2mm microbore inner, giving the minimum air loss possible from air wasted bleeding the line. It boasts a PVC coated Stainless Steel outer braid with solid Stainless Steel end fittings. It is extremely durable, flexible, and is almost indestructible. Although slightly more expensive than our other fill lines, the Ultima line offers the most extreme durability and user friendliness that you will find in any fill line.
CLICK HERE to buy Ultima Fill Lines.


2. The Microbore Fill Line.



Our Microbore Fill Lines are the same as the standard fill lines found fitted to many charging kits available on the market today. They are 2mm bore Kevlar braided units, with zinc plated steel end fittings. Although pressure rated to 400BAR, the microbore fill lines in their short 300mm configuration are extremely vulnerable to kinking on the end fittings. This represents a real problem, as the manufacturers state that if the line is ever kinked, it should immediately be taken out of service and destroyed.

The pressure integrity of the line is severely compromised after subjection to kinking, and failure cannot be ruled out. With fill pressures reaching levels of 250BAR (3,625 PSI) on some of the modern FAC rifles, no risks should ever be taken with filling equipment. It must be said though, that it is much less likely to kink the longer lines, 600mm and 1000mm as they are nut subjected to the same handling restrictions as the shorter lines. These lines are much more suited to users of stirrup pumps looking for more manageable filling solutions. CLICK HERE to buy Microbore Fill Lines.

All of our fill lines come with 1/8"BSP female end fittings as standard, but should you require a male end fitting for your particular setup, then we offer an appropriate adaptor free of charge.
We can also supply custom lines specially made to any length and configuration that you require. Please contact our technical department for more details.
For Our Selection High Quality Fill Line Fittings - CLICK HERE to buy High Quality Fill Line Fittings.

Fill Probes and Adaptors.

We now offer a good selection of different fill probes and adaptors. Currently our range includes, Air Arms, BSA, Career 707, Daystate, Falcon FN, Logun, Sumatra, Webley, and Weihrauch, and we also offer a universal Buddy Bottle Adaptor. Our Fill Probes come with standard 1/8BSP thread, or as a direct fit to our Quick Coupler System. We are adding to the range all of the time, so if you don't see what you need, please email our technical department to see if we can help. CLICK HERE to buy Fill Probes and Adaptors.